![]() I managed to keep a career when a lot of guys couldn't hold on to a job so I guess I did something right. You had to come up with tricks to stay ahead of the game. I worked in more then a few shops that if you didn't get something done right and now you were out on your ear and there was another guy filling your spot a day or two lather. I'm simply stating that the 30 minute mark was a touch long for me in my opinion. So even if I include any or all of the above hinderances, Ok fine tack on another five minutes. ![]() Annular Cutter Pilot for 0.500, 0.620 Annular Cutter (7.62 /. Now for someone that has another set up in the machine, Needs to switch from collets to a chuck, Grind a tool, yada yada yada. 1/2-28 RH Threading Alignment Tool (TAT) Die Starter Barrel Guide for. I've been standing in front of a lathe for over twenty years. I mean precision, indicated in, fine surface finish work. And I'm not talking about a hack job either. Single pointing threads for a muzzle brake take a little longer, start higher but don't go over $95.īut I'm serious any more then ten minutes to recrown a barrel is wasting time. Indicated it in front and rear take a cut, deburr and clean. ![]() On a cut and crown depending on the barrel, how much disassembly needs to be done, It ranges from $35 to $95.īut in the case above I'm assuming a barreled action that will fit in my lathe with no disassembly other then removing the stock. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |